« previous next »
Pages: [1]   Go Down

Author Topic: Stern sound problem  (Read 303 times)

0 Members and 1 Guest are viewing this topic.

Offline benpin

  • Trade Count: (-1)
  • ****
  • Forum Posts:
Stern sound problem
« on: November 05, 2011, 04:53:42 PM »
Need help here please, having problems, no sound from stern 300 sound card.

Mpu boot up and play, once you connect the sound card by the ribbon cables, MPU wont start at all, just a quick flash.

Have check the cable by buzz each end with meter. two break there which I have repair and all good.

Check the T/Points on the sound card, all good.

So what next, ideas please. !@#

 
Logged

Offline ddstoys

  • Trade Count: (+23)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong
Re: Stern sound problem
« Reply #1 on: November 05, 2011, 04:59:26 PM »
No 100% sure on these so wait for others replies there is no CPU on the sound board it uses the MPU to run the board so if there is a fault on the board it will lock up the MPU

  Here is a link to a good sight I've found on the stern 100 board might give u an idea where to start
Logged

Offline ddstoys

  • Trade Count: (+23)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong
Re: Stern sound problem
« Reply #2 on: November 05, 2011, 05:00:36 PM »
Logged

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
    • Melbourne
  • ABN 68 283 634 461
    • Ride The Boney Beast
Re: Stern sound problem
« Reply #3 on: November 05, 2011, 10:21:24 PM »

Make sure pin 1 on the sound board is pin 1 on the MPU. What you are describing sounds like the cable is installed incorrectly.
Logged
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia

Offline Ballywannabe

  • Trade Count: (0)
  • *****
  • Forum Posts:
    • Perth
Re: Stern sound problem
« Reply #4 on: November 06, 2011, 12:30:58 AM »
Except he says there are the correct voltages at the test points.  The easiest way to narrow down the problem is to have a known working soundboard on hand...
Logged

Offline JRK1971

  • Trade Count: (+1)
  • ***
  • Forum Posts:
    • Adelaide
Re: Stern sound problem
« Reply #5 on: December 07, 2011, 11:45:16 PM »
 Here is a link to an article on how to diagnose faults on the soundboard. I just used it to test mine. ^^^
http://www.pinball4you.ch/okaegi/rep_soundsb300.html


Also I posted a link on how to make an new cable for the sound board to MPU, this may help you if you need to make a new one
http://aussiepinball.com/index.php?topic=7553.0
Logged
Pages: [1]   Go Up
« previous next »