« previous next »
Pages: [1]   Go Down

Author Topic: Williams SYS 3 - 6 Display issues  (Read 318 times)

0 Members and 1 Guest are viewing this topic.

Offline ddstoys

  • Trade Count: (+23)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong
Williams SYS 3 - 6 Display issues
« on: September 06, 2009, 06:56:02 PM »
I have a Williams display in World cup thats missing segments and a digit its not the display driver board as other displays test fine in that spot and ive also tested continuity between the Connector and the glass display which are all fine is there anything else i can check or is this display stuffed?
Logged

Offline RaMpAgE

  • Trade Count: (0)
  • ****
  • Forum Posts:
    • Bendigo, Vic
Re: Williams SYS 3 - 6 Display issues
« Reply #1 on: September 06, 2009, 07:37:55 PM »
stuffed it is - like one of mine was missing some segments as well.
Logged

Offline ddstoys

  • Trade Count: (+23)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong
Re: Williams SYS 3 - 6 Display issues
« Reply #2 on: September 06, 2009, 08:52:39 PM »
BUGGER oh well it was worth asking.
Logged

Offline Pinball Fixers

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Montrose, VIC
Re: Williams SYS 3 - 6 Display issues
« Reply #3 on: September 06, 2009, 08:55:12 PM »
The display is definitely stuffed. If the fault moved, then it would have been the board/wiring/connector, but you have proved that it is the display itself.

Not much you can do about it other than replacing the display glass.
Logged

Offline ddstoys

  • Trade Count: (+23)
  • ******
  • High Score Initials:
  • Forum Posts:
    • Geelong
Re: Williams SYS 3 - 6 Display issues
« Reply #4 on: September 06, 2009, 08:57:46 PM »
Thanks Owen
                  If i cant chase up a replacement ill order a new glass  ^^^
Logged

Offline Pinball Fixers

  • Trade Count: (0)
  • ******
  • Forum Posts:
    • Montrose, VIC
Re: Williams SYS 3 - 6 Display issues
« Reply #5 on: September 06, 2009, 09:50:14 PM »
No worries mate.

Personally I'd just order a new glass, but it's up to you...
Logged

Offline FirePower

  • Trade Count: (0)
  • *****
  • Forum Posts:
    • Sydney
Re: Williams SYS 3 - 6 Display issues
« Reply #6 on: September 07, 2009, 01:30:37 PM »
Depending on what digit of the display is missing you could swap the faulty display glass into the master dispaly board. It's the same display unit but a couple of the digits are unused.

Also if things get desperate www.pinballeon.com had a guide on changin the displays over to LED units.
Logged
Pages: [1]   Go Up
« previous next »