Author Topic: Williams Pinbot Restoration  (Read 4481 times)

0 Members and 2 Guests are viewing this topic.

Offline beaky

  • Trade Count: (+7)
  • ******
  • Forum Posts:
  • Melbourne, Vic
Re: Williams Pinbot Restoration
« Reply #45 on: November 30, 2009, 11:35:25 PM »
my moving target guide had a similar problem with the broken plastic.  i tryed araldite but it only held for a few games, i repaired mine with a $2 L bracket from bunnings, i only had to redrill one hole in the L bracket.

mine didn't split down the center like that, the tab at the top where you put the screw to hold it to the play field broke off so there wasn't much surface area to glue


looking good
 
« Last Edit: November 30, 2009, 11:39:46 PM by beaky »
On site pinball repairs in MELBOURNE NTH SUBURBS  : Circuit board repairs and refurbishing Australia wide (via Aust post)