Author Topic: Williams EM Rollover - Which one is normal?  (Read 206 times)

0 Members and 1 Guest are viewing this topic.

Offline Bayview

  • Trade Count: (0)
  • ****
  • High Score Initials:
  • Forum Posts:
  • Hervey Bay. Qld.
Williams EM Rollover - Which one is normal?
« on: January 21, 2018, 02:02:40 PM »
Hi Guys,
 
Cleaning up a Williams 1976 "Toledo'.
I am doing the rollovers, and the first 2 are different to each other.
I would like to know which picture ( A or B) is the correct setup.
Picture A - just has the small washer followed by the lock washer thingy.
Picture B - has 2 extra bigger washers, one under the button between the brass fitting, and another one is put on before the smaller washer.
 
So which one is correct. A or B ? or neither.  !@#
 
Thanks
Bruce
Ya just gotta luv an EM.

Offline Strangeways

  • Pinball Restoration is my passion
  • Administrator
  • Trade Count: (+9)
  • *****
  • High Score Initials:
  • Forum Posts:
  • Melbourne
  • ABN 68 283 634 461
    • Australian Pinball Restorations
Re: Williams EM Rollover - Which one is normal?
« Reply #1 on: January 21, 2018, 08:34:37 PM »
The Washers are used to adjust the rollover to the correct height ;

These are added for this reason, also to increase the travel of the rollover to activate a switch. There is no wrong or right way to install the washers. I can lookup a parts manual and double check - but I doubt if there's anything definitive.
Aussie Pinball - Proud to be Australia's Premier Pinball Forum

APR - Australian CPR Distributor

http://www.australianpinballrestorations.com.au/

http://www.rtbb.com.au/catalog/

We carry the largest range of NEW Ramps in Australia

Offline Bayview

  • Trade Count: (0)
  • ****
  • High Score Initials:
  • Forum Posts:
  • Hervey Bay. Qld.
Re: Williams EM Rollover - Which one is normal?
« Reply #2 on: January 21, 2018, 08:51:01 PM »
Ok, cool. Thanks for the reply.
Cheers
Ya just gotta luv an EM.