Wire on PIN 1 GRN-BRN removed. Double checked yellow hack and is definately connected to GRN-RED @ PIN2.
When Spinner, ball trough 3 switches activated & flipper reports ball shooter & trough 7 still.
No credit switch or trigger launch since removing GRN-BRN..
Is there a cut grn-red wire near the hack connector under the playfield?
If so use your DMM to check continuity of this grn-red wire with the cut wire under the playfield or if you can't find a cut grn-red wire then continuity check another of the grn-red wires that go to other switches.
THE HACK APPEARS TO BE THE PROBLEM WITH YOUR MACHINE. UNTIL THIS FIXED THERE IS NO POINT DOING ANYTHING ELSE.
If it was me I'd completely remove the whole hack and start again, I like to keep all wiring original where possible.
Welcome to the world of container pin hacks
